Xantrex Link 2000 Manuel d'utilisateur télécharger pdf (Page 9)

MONITOR SETUP

Normally the only MONITOR SETUP parameter that must be changed is BATT

CAP (see bottom of this page). Please read the section on selecting charged parameters

(page 21–22)

before changing CHARGED V or CHARGED % default values. (See

FUNC SETUP on page 10 for other system values that may need to be changed.)

Setting the following parameters

only affects the operation of the monitor, mean-

ing that changing the Charged V parameter does not change the voltage set point of the

charger in the FREEDOM Inverter/Charger. It only sets the point at which the monitor

considers the battery full. To change the charging voltage during the Acceptance and

Float cycles use Ambient Temp. Setup routine. Note also that when the FREEDOM is

the charging source, the Charged % is always 2%.

SELECT BATTERY #1 OR #2: To set up a battery parameter, press the button

for the battery you wish to set up. The LED will light. Do this first as setup changes are

only made to the selected battery.

CHARGED V: The ability to set up a Charged Voltage above which the monitor

considers the battery full allows it to be used with any charging system or battery chem-

istry. The default Charged Voltage is 13.2 volts for 12-volt systems and 26.4 volts for 24-

volt systems. The LINK 2000 automatically selects the correct value based on the

voltage it senses. (If the Alternative Energy function F05 is ON, the default value is 13.5

volts or 27.0 volts. See FUNCTIONS SETUP, page 10, for details.)

To change CHARGED V follow the same procedure as described previously:

Select the battery to be set up. Press SETUP until the LED begins to flash. Then release

the button, and press CHARGED V until the desired voltage appears and then release

the button. The new charged voltage is stored in nonvolatile memory. If the charged

voltage is inappropriate for the sensed battery voltage, Error E14 is displayed (see Error

Codes and Troubleshooting, pages 28–29). Be sure to read the section on selecting

correct charged parameters (pages 21–22) before changing the charged voltage.

CHARGED %: The default value is 2%. This means that the charging current

(amps) flowing into the battery must fall below 2% of the declared battery capacity

before the meter considers the battery full. For example, using the default values of 2%

and 200 Ah means the current must fall below: 4 amps = 2% x 200 Ah.

Before changing the CHARGED % from either of these values, be absolutely

sure you understand the section on selecting charged parameters (page 21–22). Setup

and storage to nonvolatile memory is the same as for the function above.

BATT CAP: The default value is 200 Ah. The battery capacity must be set

up if it varies significantly (10–20%) from the default. The battery capacity is used in the

calculation to determine when the battery is full and in the TIME remaining function.

To change the battery capacity, press SETUP until the LED begins to flash, then

release the button. Now press BATT CAP. Scroll until the desired battery capacity is in

the display. If you are unsure of your battery capacity you may first test it as described

on page 17. The battery capacity is stored in nonvolatile memory. If you change to a

different capacity battery you must change this number. Range = 20–2000 Ah in 20 Ah

increments.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Xantrex Link 2000 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Non Xantrex Link 2000