Xantrex Automatic Generator Manuel d'utilisateur télécharger pdf (Page 108)

Relay Timing

C–2 975-0082-01-01

RunMode

For generators with RunMode starting types (Types 7 and 8):

• Relay 1 (RunStop relay) can be used for two-wire configured

generators.

• Relay 1 (RunStop) and Relay 2 (Start) can be used with a common

ground for three-wire configured generators.

• The Preheat will never overlap the Crank Time.

• The “Delay” refers to the “Preheat to Crank Delay” and may be zero.

• Cranking will cease when the generator run signal goes high for the

specified hold time or when the crank time has elapsed.

Figure C-1

RunMode timing diagram

Stop

Run

Start

Crank

Time

Preheat

Relay1: Run/Stop (Ignition)

Relay2: Start (Cranking)

Relay3: Preheat (Glow)

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 123 124

Pas de commentaire

Xantrex Automatic Generator Manuel d'utilisateur Page 108