Xantrex RV2012 Manuel d'utilisateur télécharger pdf (Page 34)

Xantrex RV Series Inverter/Charger Owner’s Manual

Troubleshooting Guide

Symptoms Problem Remedy

No power output and no

warning LEDs

Battery voltage at the inverter’s

terminals is too high or low

Check the battery voltage, fuses

or breakers and cable

connections

No power output and

LED indicator is flashing

Load too small for Search Mode

circuit to detect

Reduce search threshold setting

or defeat search mode

No power output and

warning LEDs “ON”

• High or Low battery LED “ON” • Check the battery voltage at

the inverter’s terminals

• Overload LED is “ON” • Remove loads from the

inverter and restart

• High temp LED is “ON” • Remove loads and let

inverter cool down before

restarting

Power output is low and

inverter turns loads on

and off

• Low battery • Check condition of batteries

and recharge if possible

• Loose or corroded battery

connections

• Check and clean all

connections

• Loose AC output connections • Check all AC output

connections

Inverter clicks every 20

seconds

Output of inverter wired back to its

own input

Check for proper AC input and

output wiring

Charger is inoperative or

Overload LED is “ON”

• AC input voltage does not

match inverter spec

• Check AC input for proper

voltage and frequency of

your model

• Charger controls improperly

set

• Refer to owner’s manual for

proper setting

Overload LED “ON”

while charging

Charger circuit may be damaged Have inverter serviced

Low charge rate

• Low peak AC input

voltage(164 volts peak

required for full charger output)

• Use larger generator, speed

up generator, check AC

input wiring size, adjust

charge rate, cable too small

or too long

• AC current output of generator

too small to handle load

• Reduce charge amps

setting or reduce pass-

through loads

Low AC output voltage Measuring with the wrong type

voltmeter (displays 80–100 VAC)

Voltmeter must be a true RMS

reading meter (most are not)

Low surge power Weak batteries, battery cables too

small or too long

Refer to cable and battery

recommendations in owner’s

manual

AC Lights flicker while

charging

Generator is unstable—charger is

losing synchronization

Turn battery charger rate down

until problem is gone

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Xantrex RV2012 Manuel d'utilisateur Page 34

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batteries pour voitures Xantrex RV2012